Board index » Setup And Technical




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: 1981 310 - String Gauge and Truss Rod issues
 Post Posted: Thu Aug 29, 2019 8:42 pm 
Offline

Joined: Wed Aug 28, 2019 5:10 pm
Posts: 2
Recently purchased a 1981 310.

Arrived with round .10s. Have replaced them with flat .13s IT's. This is has caused some next relief issues I am just not able to correct for some reason. I have been using the correct manual adjustment necessary for pre-1984 instruments outline in these forums.

I have contacted the store about my issues. The guitar was bought online and the listing stated that the truss rods are in working order. In my email to them, I asked if they were indeed working in the store as I am not able to correct the neck relief to accommodate the higher tension of the strings. They stated that .10 to .13 is a huge jump and it is like that the neck can't handle these strings.

Can this be true? I have read so much on these forums that .12 are a standard for short scales which makes me think the truss rods are indeed not working.

What's going on here? What should I do? Do I need to replace the truss rods?


Top 
 Profile  
 
 Post subject: Re: 1981 310 - String Gauge and Truss Rod issues
 Post Posted: Thu Jun 04, 2020 11:20 am 
Offline

Joined: Thu Jan 31, 2019 6:32 pm
Posts: 6
The jump from 0.10's to 0.13's is a huge jump for any guitar. I had similar disastrous results with a 330 (2016) and 0.12's. The neck bowed and rippled with the grain and any anomalies under the stress. I removed the strings, loosened the truss rod fully, and let it rest for about a month or more before restringing. Your neck should 'flatten' out. I suggest taking the time, start with a set of RIC No. 95406 strings, get the neck stabilized, then moving to a similar gauge set of flat wounds, before experimenting with 0.13's. You may find that 0.12's work for you in this case. I would say these guitars are engineered to perform with a narrow margin of 'change'.

I'm not sure of the exact spec differences between your 310 and an original run (pre-1971), but Mr. Hall has been quoted as saying your 330 is a "semi-vintage reissue". It may have a thinner neck than the original run. That would probably rule out heavier gauge strings

Patience is a required virtue, and remember to breathe

_________________
Rickenbacker: many big words in guitar form.


Top 
 Profile  
 
Display posts from previous:  Sort by  
 
Post new topic Reply to topic  [ 2 posts ] 

Board index » Setup And Technical


Who is online

Users browsing this forum: No registered users and 13 guests

 
 

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Register    Login    Forum    Search    FAQ
X