|Rickenbacker International Corporation - Forum|
|Rickenbacker 4003 Vintage Switch Question/Problem
|Page 1 of 1|
|Author:||soundcity5150 [ Wed Mar 02, 2016 3:54 pm ]|
|Post subject:||Rickenbacker 4003 Vintage Switch Question/Problem|
Hi @ all !!!
I've got a small problem.
I own two Rickenbacker 4003.
One from 2007 ( Amber Fireglo ) and one from 2009 (Jetglo )
They both should have the same harness and both naturally use this vintage switch.
Now I noticed,that the treble PU is sound so much fatter, or bassy in model 2007, as the model of 2009,which sounds much thinner.
I was very surprised .
I both then swapped them against each other,to look,what will happen.
But nothing has changed.
No matter what I did, model 2007 still always sound fatter.
I then compared the circuit.But everything looks the same.
Hmm,now I don´t know,what else I can do .
I prefer the thin sound, as in model 2009.
What could be the problem ?
Tolerances of the elctronic parts ( caps an pots ) ?
Or the bass itself? (Wood or construction)
But I don´t think so.The differences should not be so big, right?
I would like to solve the problem on the bass and NOT on the amplifier ( bass control )
Any ideas or suggestions?
|Page 1 of 1||All times are UTC - 8 hours|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group|