Rickenbacker International Corporation - Forum
http://rickenbacker.com/forum/

Question about neck set on new/used 360/12c63
http://rickenbacker.com/forum/viewtopic.php?f=2&t=16541
Page 1 of 1

Author:  captainvideo [ Sun Jan 20, 2019 2:35 pm ]
Post subject:  Question about neck set on new/used 360/12c63

Hey all I posted this over at the Rickresource forum, but I thought here I might get a response from Rickenbacker here.

I picked this up last week used. It's serial dates to October 2017 so I'm going to guess it left the factory like this. I have a 1993 Ric 330 I bought new back in 1994 and the bridge sits much higher, and I do realize this guitar has a different construction but that started me looking into the lowness of this bridge and comparing it to others.

What are your thoughts? Should I be concerned? I have the action at Rick spec so it's not high, but if things should go south on the neck set I don't think I could lower it too much more in the future.

I got a good deal on it and it sounds great so I'm more concerned about it just staying as is.

Attachments:
IMG_2896.jpg [113.14 KiB]
Not downloaded yet
IMG_2895.jpg [84.47 KiB]
Not downloaded yet
IMG_2894.jpg [86.22 KiB]
Not downloaded yet

Author:  captainvideo [ Thu Feb 07, 2019 7:00 pm ]
Post subject:  Re: Question about neck set on new/used 360/12c63

The guitar has been taken care of. May delete post if needed. Thanks.

Author:  maxwell [ Fri Feb 08, 2019 4:41 pm ]
Post subject:  Re: Question about neck set on new/used 360/12c63

You had a nice thread going on over at Rick Resource. I just dug up that thread to see if I missed something.... How did you resolve the issue?

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/